From everything posted so far, I bet they’re placing a header in the file system which is hidden from you, which specifics PAL or NTSC, and this is read and set at boot time because they use custom electronic circuits (ASIC) that run in one mode or another to make it cheaper / more energy efficient to process video at real-time rates versus a sufficiently powerful general processor, and restarting it can’t be done without restarting all the camera firmware
That would have made more sense than whatever they are doing, because copying the folders from an ntsc “formatted” sd card to a blank sd card works fine, same with copying pal to blank. Also you cam swap SD cards while the camera is running just fine and the camera has a few megabytes of internal storage where it stores settings.
Then my next guess is this is legacy software ported from an older device that worked that way to something new where the hardware don’t need the reboot
From everything posted so far, I bet they’re placing a header in the file system which is hidden from you, which specifics PAL or NTSC, and this is read and set at boot time because they use custom electronic circuits (ASIC) that run in one mode or another to make it cheaper / more energy efficient to process video at real-time rates versus a sufficiently powerful general processor, and restarting it can’t be done without restarting all the camera firmware
That would have made more sense than whatever they are doing, because copying the folders from an ntsc “formatted” sd card to a blank sd card works fine, same with copying pal to blank. Also you cam swap SD cards while the camera is running just fine and the camera has a few megabytes of internal storage where it stores settings.
Then my next guess is this is legacy software ported from an older device that worked that way to something new where the hardware don’t need the reboot
And they never removed the software limit