I found a hand plane at the thrift store. I think this is a #4 smoothing plane, which I hope to use for finishing. But before that, it’s quite clear that I’m going to have to clean this up a bit by removing the rust and making it look a bit prettier.

Any advice y’all have for how I might start restoring this?

  • fluxx@lemmy.world
    link
    fedilink
    arrow-up
    3
    ·
    7 days ago

    For rust removal - two main options, which one is easier for you depends on your available setup.

    1. Wire wheel in the grinder, drill press or even chordless drill. Will remove almost everything, is entirely sufficient.
    2. Citric acid, bicarb or washing soda and water and a drop of dish soap. The ingredients you can get anywhere. See the backyard ballistics channel on yt for recipe or google it out. It will remove all rust without damaging the iron, but will leave a bit dull finish.

    I recommended doing whatever you have, and not aiming for perfection, but if you want it as perfect as possible, do 2., then 1.

    I’ve restored a few planes of my own and ended up using most of them, but making it perfect is often difficult. Especially if you don’t know how it’s supposed to work and have little/no experience. Even though working principle seems easy, there are very many gotchas that will bite you in the ass. Like, blade, cap, sole, frog - each one plays a very precise role and little changes can throw a wrench in your work in no time. If it’s just for display, just make it shiny.