Lately my router seems to be struggling under all my devices and after some googling, it seems my Archer AX1800 isnt really meant for more than 20-40 devices and I’m currently sitting at 50 with heavy torrent traffic and a media server with 15-20 friends and family connected (typically not all at once of course).
I was looking at the Omada networking gear but then thought of trying OPNSense since I have pretty much everything I need on hand versus spending $400+ for the Omada stuff.
I’d like to run it on the media server since I have tons of compute/RAM available but my question is about the ethernet ports. My mobo has a dedicated 2.5Gb ethernet port built in and I have a second 2.5Gb card that I could toss in there as well, but my concern is that I may saturate the ports with all the additional traffic. My LAN is just 1Gb outside of these two PCs.
My other option is an unused Optiplex 3050 micro that I’ve installed a second ethernet port on but these would both be 1Gb ports.
Am I likely to run into saturation issues on the media server or should the 2.5Gb ports be more than enough to handle the load? Apart from the torrents and video streaming, the rest of the network is mostly typical devices like phones/tablets/consoles, 6 4K POE cameras connected to an NVR and frigate, and a bunch of IoT devices connected to Home Assistant.
I don’t necessarily mind using the Optiplex but I’d definitely prefer to keep everything in one place if I can. I realize that this means my network goes down if I restart the host but it has been a pretty rock solid setup and Proxmox means I can just restart individual containers/VMs rather than the host most of the time.
Edit: forgot to mention that I’m open to buying another quad port NIC for the server if recommended, but would definitely prefer to not spend money if possible. I was planning on using the current router in AP mode along with its ports for a switch and I have another 4 port 2.5Gb switch in the mix as well


I have run an OPNsense router like this but not through Proxmox. I did it through virtualization and did a direct PCI passthrough. The main thing is I needed 3 Ethernet ports for this setup to work. It does create at this point as bare metal you can get through virtualization. I am not a network engineer so take what I say with some salt.
I would recommend it but I am confused by some things you have. It sounds more like a switch is needed and the 2.5g to be setup on the LAN side while 1g wan. Most providers don’t go above 1g wan. The router will not be used in an unmanaged switch as it will do direct connections. A managed switch would need some of the traffic to go through the router. The router would only be needed from LAN to WAN.
Main thing is that the internet goes down any time your host updates or router. Booting host then VM can take a few min in some cases.
Level1tech on YouTube has a detailed walkthrough on this type of setup.